HullSonic MAX4
The flagship: four commercial-duty channels
HullSonic MAX, formerly CleanAHull: four auto-calibrating channels at 60 W each (240 W), channel grouping, alarm and isolation I/O, colour display, WiFi and over-the-air updates.
Specifications ↓
The flagship. Four commercial-duty channels, 240W of ultrasonic energy, and full integration into the vessel’s systems.
MAX4 is everything GLOBAtech learned running ultrasonic systems on commercial vessels, specified for superyachts and serious cruising hulls.
The complete MAX specification
Four independently auto-calibrated channels, each user-configurable from 45–65W and factory-set to 60W — 240W of ultrasonic acoustic energy across the installation. Every channel tunes itself continuously across the 19–80kHz band to the acoustic load of the hull section it’s bonded to, because a transducer on a keel root and one on a topside panel are not the same problem.
Channel grouping across two zones
MAX4 can bond its four channels into two matched pairs, driving each pair as a single coherent acoustic zone. On large flat hull sections, sea chests and strainer boxes, that’s the difference between even coverage and two sources loading the same structure out of step. Or run all four independently. It’s your call, per installation.
Integration I/O
- Alarm header — channel fault and system status to the vessel’s monitoring or alarm system. On a managed vessel, a failed transducer should raise a flag at the panel, not be discovered at haul-out.
- Isolation input — clean external inhibit for diving operations, hot-work, in-water survey or class inspection, without touching breakers.
- External boost input — trigger BOOST from a VMS, timer or switch for scheduled high-output periods ahead of a lay-up or through peak fouling season.
Where this technology comes from
MAX is the superyacht expression of two decades of GLOBAtech engineering on working vessels, where systems run continuously and downtime is expensive. MAX4 is that engineering, packaged for a yacht.
Formerly CleanAHull 4-Channel, now consolidated into HullSonic.
Colour display, WiFi and over-the-air updates
Full-colour per-channel status, drive power, grouping configuration, calibration state and fault reporting. WiFi for configuration, diagnostics and OTA firmware updates — a system that improves after it’s commissioned.
12–24 V, auto-sensing
One unit for both bus voltages. No configuration, no variants.
Each transducer has 10 m (32 ft) of cable attached. On a larger boat a cable may need extending to reach its transducer: contact us for advice. Bigger boats combine systems, and the layout planner works out how many transducers yours needs.
A closer look
What's in the box
HullSonic MAX4, 4 active commercial-duty channels
Each with 10 m (32 ft) of silicone rubber cable attached
Bonded inside the hull; each transducer screws into its ring
A tube of Loctite 515 for the transducer faces
5 m (16 ft) silicone rubber battery cable, already attached to the module
JB Weld epoxy adhesive and mixer
In-line fuse and a spare fuse kit
Full-colour installation and operation manual
HullSonic MAX4 at a glance
Clean hulls, in their words
See where the transducers go on your boat
Pick your boat, drive and what you want protected. The layout planner draws the transducer positions on your hull and puts the matching system in your cart.






