HullSonic HS200
Two transducers on a 4-channel controller
Ultrasonic antifouling for leisure vessels: the full four-channel HS control module with two transducers. Channels 3 and 4 are installed and switched off; add the HS transducer upgrade kit any time.
Specifications ↓
Stop fouling before it starts. Protection for vessels to 32ft/10m, on a control module that grows with your boat.
The HS200 is a full four-channel HullSonic control module supplied with two transducers — channels 3 and 4 are ready and waiting for the day you want them.
Four channels of hardware. Two working today.
The HS200 isn’t a cut-down system. It’s the same control module as the HS400, with two of its four ultrasonic channels held inactive. Add the HS transducer upgrade kit at any point and the system becomes a full four-transducer installation — no new module, no re-wiring the power feed, no writing off what you already bought.
For most owners of vessels to 32ft/10m, two transducers is exactly the right specification. The upgrade path is there for the ones who move up, add a keel cooler, or simply want more intensity on a high-fouling mooring.
Real power, under your control
Each channel delivers a user-adjustable 45–55W, factory-set to 50W — that’s 100W of ultrasonic acoustic energy across the two active transducers. Every channel calibrates itself continuously across a 19–80kHz swept band, automatically compensating for hull thickness, material, and the acoustic load of your specific installation. Hull composition changes the resonant behaviour of a transducer; the HS200 measures it and tunes to it, per channel, instead of guessing.
ECO, STANDARD and BOOST — match the system to your power budget
- ECO — reduced draw for boats on solar, wind or limited shore power. Protection continues; consumption drops.
- STANDARD — the everyday setting. Factory default.
- BOOST — maximum output for high-fouling seasons, warm water, or a boat that’s about to sit for a while.
A programmable sleep function will stand the system down for 4–8 hours and resume automatically, for owners managing tight battery budgets on a mooring.
The colour display tells you what’s actually happening
A full-colour display gives you live per-channel status, drive power, calibration state and fault reporting at a glance — not a blinking LED you have to interpret. Onboard WiFi handles configuration and over-the-air firmware updates, so the system you install this season keeps improving.
Built for a 12V or a 24V boat
Auto-sensing 12–24VDC input. No jumpers, no variants, no ordering the wrong one. Move the unit to a different vessel and it adapts.
Each transducer has 10 m (32 ft) of cable attached. On a larger boat a cable may need extending to reach its transducer: contact us for advice. Bigger boats combine systems, and the layout planner works out how many transducers yours needs.
A closer look
What's in the box
HullSonic HS200, 4-channel hardware with 2 channels active
Each with 10 m (32 ft) of silicone rubber cable attached
Bonded inside the hull; each transducer screws into its ring
A tube of Loctite 515 for the transducer faces
5 m (16 ft) silicone rubber battery cable, already attached to the module
JB Weld epoxy adhesive and mixer
In-line fuse and a spare fuse kit
Full-colour installation and operation manual
HullSonic HS200 at a glance
Clean hulls, in their words
See where the transducers go on your boat
Pick your boat, drive and what you want protected. The layout planner draws the transducer positions on your hull and puts the matching system in your cart.




