Support

Troubleshooting

Most issues come down to power, a transducer’s bond or a gap in coverage. Start here.

Start here

Quick checks

Power

Is it on?

The system must run continuously. Check the supply, the fuse and any isolation switch.

One channel

A fault on the display

Check that channel’s cable and connector, then the transducer’s bond to its mounting ring.

Coverage

Growth in one area

That area may be outside the coverage zones. Check the layout in the planner.

Mode

Growth everywhere after a long stay

Conditions may call for STANDARD or BOOST rather than ECO.

HS control module

What normal looks like

A system that is working

  • Status light Steady green, or a regular green pulse.
  • Display The normal operating mode, with no warning or error message.
  • Sound Nothing you can hear in the boat. Right beside a transducer there may be a faint click.
  • Power A few watts per transducer on average, in short bursts.

Lights and channel status

What the control module is telling you

Orange light (warning)
At least one transducer needs attention. Check the display for that channel’s status, then its cable and connections.
Red light (error)
A system fault. Read the message on the display, switch the system off and on again, and contact us if it comes back.
Red flash every two seconds
Low supply voltage. Check the battery’s charge, the connections and the voltage at the control module.

Channel status letters on the display

  • H High power
  • L Low power
  • – Channel switched off
  • X Disconnected
  • S Short circuit
  • D Detached from the hull

Lights and messages vary a little between models. Your manual has the full list for yours.

Growth on the hull

If you still see fouling

  • It was there before The system stops new growth; it does not remove barnacles and hard growth that had already attached. Have the hull cleaned once, then let the system keep it clean.
  • The antifouling paint is worn out The system works with your paint. Where the paint has worn through or has no life left, growth can still take hold; touch up or recoat.
  • A gap in coverage Each transducer covers a zone about 4.5–5 m across. Growth in one patch, behind a keel or skeg, or around a thruster tunnel points to a gap. Check the layout in the planner.
  • A transducer has come loose Check each one is tight in its ring and the ring is still bonded all the way round.
  • Conditions changed Warmer water, a new berth or a spawning season raises fouling pressure. Switch from ECO to STANDARD or BOOST.

Still stuck?

What to send us

  • The model and serial number, and when it was installed
  • The boat: type, length and hull material
  • What you are seeing and when it started
  • A photo of the display, and photos of any growth or damage

The full guide: Troubleshooting guide: getting the most from your HullSonic system.

Plan my layout